Next generation sensor with Double Induction technology… The dual processor captures the tip magnet's mark guaranteed. Its one-piece, unified design does not require extra space in the control panel. It has 2 sensitivity settings, High-Normal. It provides a guaranteed solution for tip finding, sampling and tour control while removing fabric. Easy detection at any speed 0.01-10 m/s , 24 V DC (18-30 V DC) supply voltage, Normal 0-25 +/- 5 cm sensing distance, Sensitive 0-35 +/- 5 cm sensing distance
New Generation Sensor with Induction Technology One-piece unified design that does not require space for the control panel, Sensitivity adjustment, Convenient solution for tip detection and lap checking when removing fabric, Best price/performance for basic tip detection applications, Easy detection at any speed 0.01-10 m /s, Solid, unified design, 24 V DC (18-30 V DC) supply voltage, Normally open contact output (MOSFET), Normal 0-25 +/- 5 cm sensing distance, Sensitive 0-35 +/- 5 cm detection distance
The PD3xx is a hydrostatic level meter that calculates the level in the tank by measuring the water pressure. Its output is a standard two-wire, 4-20 mA current circuit. The stainless steel diaphragm is suitable for chemicals used in the textile finishing industry. This allows it to be mounted directly to the measurement location. This
eliminates the calibration process required in air-insulated systems.
The P3xx is a hydrostatic level meter that calculates the level in the tank by measuring the water pressure. Two standard outputs corresponding to 0-100 mBar for the P300, 0-200 mBar for the P320, 0-300 mBar for the P330, 0-400 mBar for the P340, and 0-500 mBar for the P350. -wire (two-wired) is a 4-20 mA current loop. It is mounted vertically at the same level as the tank, air-insulated. The location of the sensor should be above the highest water level.
The P4x is an air-insulated hydrostatic level meter that calculates the level in the tank by measuring the water pressure.
Its output is a standard two-wire, 4-20 mA current circuit. It is mounted on the rail in the panel with air insulation. The position of the sensor should be above the highest water level.
